storing-your-mower
maintain, mower info

Storing Your Mower

The mowing season is coming to an end, and winter is just around the corner! Once you’re done mowing for the year, replace any worn parts and properly store your machine to help ensure it is ready for next spring.

If you’re planning to do your own maintenance or just want to see what Toro recommends, here are tips that will help you prepare for winter. See your operator’s manual for further details on performing any of the maintenance mentioned.

If you prefer to have a dealer do any necessary maintenance or repairs on your mower, now would be a good time to contact them. Once spring comes, their shops will be extremely busy, and they could have long delays.

  1. Fuel system preparation
    Add fuel stabilizer/conditioner to the fuel tank. Run engine for five minutes to
    distribute conditioned fuel through fuel system. Stop engine, allow it to cool, and
    drain fuel tank or run engine until it stops. Either choke or prime the engine, restart it
    a third time and allow it to run until it stops. Continue to attempt to restart the engine
    until it no longer will start.  While the engine is still warm, change the engine oil (and filter, as applicable), if this service is due.
  2. Cylinder/Piston care
    4-cycle engines
    Remove spark plug and add about one tablespoon of oil through spark plug hole.
    Slowly rotate engine several times using starter rope or key starter to distribute
    oil. Reinstall spark plug, but do not connect spark plug wire.
    2-cycle engines
    Slowly pull recoil starter until resistance is felt due to compression pressure, then
    stop. Release starter tension slowly to prevent engine from reversing due to
    compression pressure. This position closes both the intake and exhaust ports to
    prevent outside air entry, which can result in corrosion of the cylinder bore.
  3. Tighten fasteners as needed.
  4. Service air filter as described in operator’s manual.
           
  5. Clean unit thoroughly.
                                                             
  6. Touch up all rusted or chipped paint surfaces.
  7. Battery (if applicable) –
    Remove battery from unit and fully
    charge prior to storage.
  8. Replace damaged or worn parts.
  9. Sharpen and balance the mower blade(s).
     
  10. Lubricate unit per the operator’s manual.
  11. Storage
    Ensure engine has cooled. Cover unit and store in a clean, dry location out of the reach of children.  Note: Never store unit in house (living area) or basement where ignition sources may be present, such as a hot water heater, space heater, or clothes dryer. Gasoline and fumes are highly flammable and explosive. Fumes also can be dangerous if inhaled.
Share:
  • Facebook
  • Twitter
  • Print
  • Reddit
  • Digg
  • del.icio.us
  • StumbleUpon

Comments are closed.